GLASAIR GLASTAR

GLASAIR

GLASTAR

5583

New

Serial Number: 5583 Options: Original kit Purchase 1. Dual aluminum wing fuel tank kit 2. Cleveland dual piston dual brake kit 3. Factory Taildragger kit (Trike installed) 4. Quick build kit - Factory assembled fuselage and spars 6. GlasTar Molded Instrument Panel – Three Panels * Setup for Falcon Avionics package (Pro + two minis) * Apple iPad Pro 12.9” 4th GEN WiFi + Cellular 7. Cabin Air Vent kit 8. Options: Purchase by "Me". (New) Sportsman Aileron Anti-Servo Kit - #921-06100-01 (New) Sportsman wing aileron balancing servo (New) Sportsman 6x6 wheel cowlings (New) 6x6 tires + tubes (New) GlaStar original trike kit: # 937-02000-01 (New) GlaStar original seat belt kit (New) GlaStar original cast rudder pedals kit - #991-02000-01 (New) GlaStar original flush fuel caps kit (Locking): # 201-40004-01 (New) GlaStar original wing brace kit: # 902-01000-01 (New) Dynon heated pitot kit (New) Alpha Systems vertical dash mount AOA kit w/ heated pitot (New) Lighted rocker panel switches Powder coated: Door hinges, foot rudder controls, tail-dragger rear mount kit (New) LP AERO PLASTICS, Inc. - Front side door window portal kit with window openings. (New) FiberTech ceiling mount switch panel kit and exterior speed mods (New) Micro AeroDynamics, Inc. Micro Vortex Generators for wings & tail (New) Sportsman wing light lens kits (New) Sportsman wing bushings – Flaps & Aileron (New) Rear vertical tail top cap for using TailBeaconX + uAvionix TailBeaconX EXP (New) Falcon Avionics & engine management kit (New) Dynon comms module (New) Comms antennas with cables (New) Andair Fuel Selector P# FS20X-F (New) Interior top window shade kit purchased Service Bulletins & AD's: Purchased directly from Glasair Aviation All have been purchased and installed. Plane’s Current Status: I have all the build pictures and documents for all... The airplane has been sitting in my hanger in Goldthwaite at T37 It has been sitting since my car accident April 25th 2016. * All work was completed/performed prior to my car accident. Metal work has been mostly completed up to inspection ready in some areas. The wings still need some lights installed with cabling and wires. The wings also need to be fitted to fuselage. The roof on fuselage still needs to be installed prior to fitting wings. All doors are completed and installed. Rudder pedal assembly is complete. Flap lever/handle is complete with four position points. I added a 10% flap notch. All inner fuselage is 50% complete. Needs pulley cabling, electrical, dash electronics, FWF, tail section cabling & etc… Fuselage interior has been painted