N63JN - 1997 BEECHCRAFT B36TC BONANZA

1997

BEECHCRAFT

B36TC BONANZA

Used

N63JN

IFR

KDVT

1997 B36TC Bonanza by Elite Air Center Ownership History: Arizona: November 2023 – Present New York: 2007 – 2023 Utah: 2006 – 2007 Japan: New - 2006

5061

Total Time: 5,061 Complete logbooks available by request Annual Inspection completed 5/2026 Oxygen bottle hydrostatic test completed in 2025 Max Takeoff Weight: 3,850 lbs Fuel Capacity: 108 Gallons with 102 Gallons Usable

349

SMOH

1600

Engine Make/Model: Continental TSIO-520-UB 300hp Turbocharged Engine with GAMIjectors, TurboPlus Intercooler, and new engine baffles Engine Time: 349 SMOH by RAM Aircraft in 2023

Props: Hartzell PHC-C3YF-1RF 3-Blade Hot Props Propeller Time = 705 SOH by New England Propeller Services in 2019

Garmin G500 TXi PFD/MFD with Synthetic Vision Garmin GFC 500 autopilot Garmin EIS TXi connected to CiES digital fuel senders Garmin GTN 750 #1 GPS/Nav/Comm with TelligenceTM Voice Command Garmin GNS 650 #2 GPS/Nav/Comm Garmin Smart Glide Flight Stream 510 Garmin GMA 35C remote audio panel Garmin 345R remote transponder with ADS-B In/Out Garmin GI275 ADI on pilot side Garmin GI275 ADI on co-pilot side Garmin GI275 HSI on co-pilot side New powder coated, single piece instrument panel Newly refurbished electroluminescent light panels Dual LEMO headphone plugs on panel for pilot and co-pilot Dual LEMO headphone plugs wired near rear facing passenger seats

Factory Air Conditioning TurboGAMIjectors Backup generator Reif oil sump heater pads and thermostat Battery Tender airframe interface installed for use with Concord battery All LED external lights and strobes Electronic carbon monoxide detector Rosen sun visors G&D Aero thermal window inserts Co-pilot brake pedals

Original paint - Jade Mist Green/Black/Gold Metallic. Refurbished in 2026

Original leather cabin seat coverings New carpet floor and sidewalls from SRS interiors in 2026 Front seat shoulder harnesses re-webbed in 2025 Repaired and recovered glareshield in 2024 Covered pilot and co-pilot yokes with leather in 2024

Inspection Status: Annual Inspection completed by Cutter Aviation in May 2026 Recent Maintenance Highlights: Installed Battery Minder airframe interface - 2026 New Concord battery – 2026 Replace fuel flow transducer – 2026 Painted landing gear – 2026 Complied with AD 2023-09-09 V-band clamp inspection - 2025 Low compression on cylinder #3 repaired by RAM – 2025 Install Reiff oil sump heater pads and thermostat – 2023 Damage History: Inadvertent gear retraction during touch-and-go in 2006. Imported from Japan and repaired in USA.

Yes