2018 BOEING BBJ2

2018

BOEING

BBJ2

Used

FAA FAR Part 91 Compliance Delivered in June 2018 Total 4 Cockpit Seats + 2 Cabin Crew Seats + 27 TTOL Passenger Seats Six Zone Cabin Configuration Low Cabin Altitude System (6,500 ft cabin altitude at 41,000 cruising altitude) Thermal and Acoustic Insulation Upgrade Satcom & Internet Access Additional Potable Water Tank 5 Auxiliary Fuel Tanks (0 Fwd / 5 Aft)

0.0

- Manufacturing Year: 2013 - Delivery Year: 2018 - Delivery Hours & Cycles Only

Engines Model: CFM56-7B - Each Engine Total Hours: 35 Since New - Each Engine Total Cycles: 15 Since New

- ACARS: AOA-capable CMU, ARINC 607 Type II APM - Air Data Computing System - Air traffic control (ATC) system - Air data inertial reference system (ADIRS) One (1) Ail Systems VOR / ILS - One (1) Artex Aircraft Supplies Emergency Locator Transmitter - One (1) Flight Dynamics Heads Up Guidance System - Two (2) GE Aviation Systems MCDU-FMS - One (1) Honeywell EGPWS - Two (2) Honeywell Inertial Reference Unit - One (1) Honeywell Ground Proximity System - One (1) L-3 Communications Cockpit Voice Recorder - One (1) L-3 Communications Flight Data Recorder - Three (3) Rockwell Collins VHF COMM Transceiver - Two (2) Rockwell Collins HF COMM Transceiver - Two (2) Rockwell Collins Automatic Direction Finder - Two (2) Rockwell Collins GPS - One (1) Rockwell Collins Weather Radar - Two (2) Rockwell Collins DME Interrogator - Two (2) Rockwell Collins ATC Transponder - One (1) Rockwell Collins TCAS 7.1 System - Two (2) Rockwell Collins LRRA Transceiver

Cockpit: The existing aircraft overhead panels, instrument panels and center console will be modified, or reconfigured as required to accommodate new systems to be installed (smoke detection indicator panel, cabin door warning panel, etc). All other items in the cockpit will be retained as delivered. Lavatory: The crew lavatory shall be retained as delivered with the aircraft on the inside. The outside of the crew lavatory is to be redecorated. Entry Area: The Entry area encompasses the area from the cockpit door to the Forward Seating Area bulkhead. It incorporates the right hand Forward G1 and G2 Galleys, and the left hand Flight Attendant seats and Lavatory A as delivered with the aircraft. Galley Equipment: The following items shall be installed into the Galleys: G1 Galley: - Coffee Maker and Coffee Pot (Qty 1) - Oven (Qty 1) - Half Size Waste Carts (Qty 2) - Half Size Cart (Qty 1) - Waste Compartment (Qty 1) G2 Galley: - Oven (Qty 1) - Refrigerator/freezer (Qty 1) - Water Boiler (Qty 1) - Half Size Carts (Qty 4) - Full Size Cart (Qty 1) - Waste Compartment (Qty 1) Forward Seating Area The Forward Seating Area will encompass the area between the Galley aft bulkhead to the Mid Cabin Lavatory on the right hand side. The Forward Seating Area will also encompass the area between the left hand side bulkhead at the aft end of the Entry Area to the forward bulkhead of the VIP Lounge Area. The Forward Seating Area will be designed to provide maximum comfort for the passengers and have a level of elegance commensurate with a VIP cabin. The Forward Seating Area shall have the following installed: - Two (2) UTAS Executive (16G) Dynamically Certified Double Seats - One (1) UTAS Side Facing 3 Place 16g Divan - Two (2) UTAS Executive (16G) Dynamically Certified Single Seats - One (1) Dual Pedestal Hi-Lo Table with Folding Leaves on the Right Hand Side of the Aircraft - One (1) Wardrobe on the Left Hand Side - One (1) VCC Cabinet on the Right Hand Side - One (1) Side Ledge on the Right Hand Side - One (1) Side Ledge on the Left Hand Side - One (1) Cabin Divider with Curtain Located at the Forward End of the Compartment - One (1) Cabin Divider with Curtain Located at the Aft End of the Compartment - One (1) Cabin Divider with Curtain Located Around the Crew Lounge Seats - Four (4) 230V PED Outlets - One (1) 32 inches Monitor - Cup Holders and Switches will be Fabricated and Installed per the IDP and Switch Block Diagram The Mid Cabin Lavatory is the compartment on the right hand side of the aircraft between the Forward Seating Area on the forward side and the VIP Lounge Area on the aft side. The Lavatory shall have the following installed: - One (1) Vacuum Flushing Toilet - One (1) Toilet Fhroud Assembly - One (1) Vanity Cabinet - One (1) Storage Cabinet - One (1) Vanity Counter - One (1) Sink - One (1) Faucet Assembly - One (1) Lighted Mirror Assembly - One (1) Potable Water Filter - One (1) Water Heater - One (1) 230V Outlet - Towel Bars and Soap Dispenser The VIP Lounge Area is the compartment between the Forward Seating Area and the Mid Cabin Lavatory on the forward side and the VIP Dining Area on the aft side. The VIP Lounge Area shall have the following installed: - One (1) Forward Wardrobe on the Right Hand Side - One (1) Five Place U-shaped Divan - Two (2) Single Pedestal Hi-Lo Tables with Folding Leaves on the Left Hand Side of the Aircraft - One (1) Privacy Curtain to the Forward Seating Area - One (1) Polarized Privacy Partition on the Aft Side - One (1) Upholstered Surround - One (1) 55 inches Monitor - Two (2) 230V PED Outlets The VIP Dining Area is the compartment between the VIP Lounge Area on the forward side and the Meeting Area on the aft side. The VIP Dining Area shall have the following installed: - Eight (8) UTAS Executive (16G) Dynamically Certified Single Seats - One (1) Dual Pedestal Hi-Lo Table with Folding Leaves - One (1) Buffet on the Right Hand Side (Forward) - One (1) Privacy Curtain to the Meeting Area - Two (2) Credenzas with Seat Cushions on the Left Hand Side (Forward and Aft) - One (1) Credenza on the Aft Right Hand Side - One (1) 42 inches Monitor - One (1) 230V PED Outlets - One (1) 115V/60Hz PED Outlet The Meeting Area is the compartment between the VIP Dining Area on the forward side and the VIP Office on the aft side. The Meeting Area shall have the following installed: - Four (4) UTAS Executive (16G) Dynamically Certified Single Seats - One (1) Electro-mechanical Mahjong Table shall be Purchased Commercially and Adapted to Meet all Aircraft Certification Requirements. (A Secondary Table Top shall be Fabricated that will Rest Upon the Mahjong Table to allow Meetings to be Conducted without Damaging the Mahjong Table.) - One (1) Privacy Curtain to the VIP Office - Two (2) Credenzas with Seat Cushions on the Forward and Aft Sides of the Meeting Area - One (1) Credenza on the Right Hand Side - One (1) Side Ledge on the Left Hand Side - Two (2) 230V PED Outlets